# Not all interfaces appearing on rmap.world

_Help · started by b1LL on Fri, Sep 11, 2026 6:31 PM_

---

## Original post

**b1LL** · Fri, Sep 11, 2026 6:31 PM

I have several interfaces running and for some reason only two of them appear on rmap. 

Config:
  [[xxxx]]
      type = RNodeInterface
      enabled = yes
      port = /dev/ttyACM0
      frequency = 914875000
      bandwidth = 125000
      spreadingfactor = 10
      codingrate = 5
      txpower = 17
      discoverable = yes
      discovery_name = xxxxxx
      latitude = xxxxx
      longitude = xxxx
      height = xxx
      announce_interval = 720

  [[Reticulum_Gateway]]
      type = BackboneInterface
      mode = gateway
      enabled = yes
      listen_ip = 0.0.0.0
      listen_port = 4242
      reachable_on = mesh.xxxx.org
      discoverable = yes
      discovery_name = xxxx_rns_Gateway
      discovery_stamp_value = 16
      latitude = xxxx
      longitude = xxxx
      height = xxxx
      announce_interval = 720

[*These two above appear on rmap, then I have several additional backbone interfaces not shown here that are not discoverable, and then finally I have the Yggdrasil interface which does not show up on rmap*]

  [[Yggdrasil Gateway]]
      type = BackboneInterface
      enabled = yes
      discoverable = yes
      latitude = xxxx
      longitude = xxxx
      announce_interval = 720
      target_host = 201:xxxx
      target_port = 4343
      listen_on = ::
      port = 4343
      reachable_on = 200:xxxxx

The Yggdrasil interface itself is working appropriately, would just like for it to show up on rmap to encourage community involvement. Thanks.

---

## Reply 1

**Anonymous** · Fri, Sep 11, 2026 7:53 PM

I believe rmap doesn't display discovered Yggdrasil interfaces given there are quite a few in the network and rmap doesn't have a category for them.

---

## Reply 2

**Anonymous** · Fri, Sep 11, 2026 7:55 PM

Although you could try contacting their LXMF linked on https://rmap.world/info.html

---

## Reply 3

**b1LL** · Fri, Sep 11, 2026 8:10 PM

**Anonymous** wrote:
> I believe rmap doesn't display discovered Yggdrasil interfaces given there are quite a few in the network and rmap doesn't have a category for them.

They should just fall under backbone, right? I was trying to copy this node on rmap

![Screenshot 2026-09-11 at 10.09.19.png](/storage/forum/svXQO95JC7UHAWfQElm67stE4qShStuYMM4sFPSk.png)

---

## Reply 4

**Anonymous** · Sat, Sep 12, 2026 10:00 AM

I was unable to successfully contact them unfortunately. Unsure if the lxmf address is still used.

---